I used to run them on my stroker motors in the '70s. If you continue, you consent to all cookies on RevZilla. Had the 69 out today with the Tillotson and it runs like a champ. Leaky float bowls can drip gas all over vintage Japanese motorcycle engines. Carburetor - Parts
Always consult with your dealer about any Stage Kit-related modifications. I still do lots and lots of carburetor clean-outs for friends. So, for the record, I encourage you to use new gaskets. To optimize engine performance and to minimize the risk of engine damage , any changes to the intake and exhaust system must be accompanied by an increase in fuel flow. Hex-head cap screws make excellent replacements if they do indeed strip. This carburetor is in very good condition and shows normal signs of wear.
Over here there are very few people who understand those carbs and I may end up doing it on my kitchen table: Didn't think of NOS and Tillotsons before. It is a little dirty from previous use and storage but it looks good. This nozzle kit you reach a performance increase of up to 10HP. Its been that way for Oh , 20 years. Fits Shovelhead FX Models
Easy to install without directions. You want to get out all the scummy stuff like you can see in the photo above. If a mechanic is going to charge you a few hours of labor to remove your carbs and clean them, you will be paying for a stem-to-stern overhaul. What you see is what you get. Manifold seal, TC, James, 2-pack. Applying the same quality and attention to detail to motorcycle parts as we do everything else no one leaves unsatisfied.